Uneven first layer

[Cesar_Maciel]

Hey guys. I have a problem with my prints.

As you can see in the image above, even using a glass table and automatic leveling, my first layers have several irregularities, as if in some points the nozzle touches the table too much, and in other points it touches less.

Has anyone seen something similar?
(If there is already a topic similar to this I apologize, it is my first time on this forum)

[patrickd57]

I have the same problem, some areas it drags the plastic around without adhering to table.

[Cesar_Maciel]

Did you try to print this?

Bed Leveling Calibration Test Object (Parametric) by pgreenland

It helps a lot to check what point of your bed is warped or lacks calibration.

[patrickd57]

Thank you so much, made a huge difference. Also helped identify poorly coded prints, never going to work.