When I turn my printer on, and the bed moves along the Y-axis to the back where the switch is, it normally has bounced once or twice and then centered the bed and the print continued. This morning after attempting to start my printer, it moves the bed towards the switch and when it bounces, it jitters like the belt is trying to move when the bed is all the way to the end of it’s travel. The only thing that I know I did was to update Creality Print and use it for the first time vs the Cura program I have been using. Now after the issue I just described, the printer freezes and does nothing until I shut the power off. Any suggestions? It is making contact with the limit switch.
Could be a broken limit switch or some debris in the limit switch. Which printer in particular?