Anyone have popping and exposed wires in their K1?

[tjan]

right fan runs into this plug.

you should look at this post of my too

K1 max Linear X axis rail MGN12 upgrade. (no rooting needed!)

I made the X Axis modification/upgrade by installing a linear rail MGN12 on my K1 max. The gliders I downloaded from cults3d, a design made by “lashigt”, and made some adjustments on them by making the holes for the teethed gears little bit larger to 4mm diameter so I could use m4 bolts for the Idler gear 20T 5mm. The printing results are great (Less till no VFA anymore on your prints) and a big improvement of the K1 max without having to root the machine. Key components to buy : 1pcs - Li…

I do not understand your last question. (but maybe you can buy a new bearingholder and bearing at the topback in the middle)

here you can see the bearing at the top of the leadscrew