So I bought the ceramic hot end kit and it’s just not extruding, I’ve checked everything and it looks good but then I pulled the filament twice out and this what happens, why ?
Changed today to the old hotend and everything working fine which is strange I thought maybe some wire was not working, if I am heating to 240 and pushing the fillament everything looks good it only when printing
looks like the extruder is too tight on the filament. Unfortunately I am printing so can’t fiddle. From memory:- take the cover off and there is a extruder tensioning screw on the right side of the extruder to adjust the tension. The extruder should only lightly grip the filament, yours looks like it is gnawing its way through.