Cr touch sensor error Ender 3 v3 SE

Well it turns out I’m not sure that is the issue. For the 2194 error I have taken everything apart and put it back together. Checked for bent pins and bad connections on everything even the 30 pin cable to the board and carriage and everything looks good. I still have the error but can click ok pull out the pin on the touch and it seems to work. I oiled the pin and it does not seem bent at all it moves very easily.

I saw the post about adding 8 volts but that is a magnetism issue and should only happen when it gets hot. My issue happens after sitting all night and trying to print so it shouldn’t be that hot.

My next move is to switch out the touch but I really don’t think that’s it.

Any suggestions?