stepper drivers TMC2208
TJC screen
firmware tried: E3V2-BLTouch-5x5-v4.4.4-v2.01.bin
Ender3V2-422-BLTUBL-MPC-20240125.bin
home compile of above
Issue: Z axis will not home. Z axis only moves in positive direction
Pronterface interface can drive in positive direction only for z axis.
can deploy and stow BLtouch pin
can move in X and Y directions
M999 can not clear Z axis error.
Is there a command that can clear the erroneous Z axis error?
I have checked all wiring with Ohm meter and can confirm proper wire placement.
Is the probe bad?