Ender-3 V2 With Linear rails X and Y, Cr Touch and Sprite Extruder Pro Axis Calibration Problem

Hello everyone, I recently purchased my Creality Nebula Smart Kit and installed it on my printer, I noticed that during the initial configuration stage the CR Touch Probe is performing the Z Calibration outside the center of the table and that when doing the Mesh Leveling the probe is trying to calibrate outside the table area causing the nozzle to collide against the table. How to adjust these parameters?

When I used the Ender-3 V2/S1 Professional Firmware firmware (By Mriscoc) I was able to make the adjustments on the printer itself. But in Nebula Pad there are no options for Axis adjustments.