Hello, I have gotten my hands on an Ender 3 V3 SE printer, and after replacing a faulty sensor, I have gotten the printer running. Though it appears to be stuck in a never-ending loop, where whenever I power it on it presents me with the select language prompt and begins adjusting the Auto Z Offset. I decided to let it run its loop in the case it would resolve all commands, but it has been at it for over an hour, where it asks me to select a language, and no matter which one I pick it auto-levels, and repeats the process again. I first checked that no sensor was malfunctioning, by replacing them with brand new ones, and then installed the latest V1.10 firmware with a micro SD card. Still though this has not stopped the loop. I am unable to access the screen menu since it forces me on the language prompt. Is there any way someone could help?
If you bought it at a store or online, return it for warranty…