Firmware for Nebula pad for Ender-3 V3 SE?

Ender Series Creality Ender-3 V3 KE/SE
1

I am a blogger from Ukraine, I review 3D printers.
After the review on the Ender-3 V3 KE, I decided to check whether the Nebula pad would work with the Ender-3 V3 SE (with firmware taken from the Sonicpad).
Nebula pad sees the printer, but due to the displacement of CR-Touch it cannot carry out the auto-calibration procedure.
Therefore, the question is whether you already have ready-made firmware for the Nebula pad for the Ender-3 V3 SE version.

I also remind you that in Ukraine this is the most popular printer today. More than 1000 users use the Ender-3 V3 SE version and will be grateful for the opportunity to upgrade.

2

Hi @Bootuse and welcome to the forums.

As far as I know the Sonic Pad requires a USB to Serial cable to be able to communicate with the Ender 3 V3 SE. My guess is that you may also need the same cable to connect the Nebula Pad to the V3 SE too.

Here is a link to the store page for the serial cable:
https://store.creality.com/products/creality-sonic-pad-serial-cable

If you need information regarding upcoming firmwares you would need to contact Customer Support via email: cs@creality.com