Laser moves into X-Direction slowly after homing, Motorcontroller-Issue?

Hello everyone,
I unpacked my Creality Falcon2 Pro, started up and connected to a computer with Lightburn. Lightburn finds the Lasercutter.

The problem is, that after power on of the Lasercutter, the Lasercutter slowly moves to the right (along X-Axis) until the end and continues trying to go right.
Is there an issue with the X-Axis motor controller? Hope its not a hardware issue…
Any hint would be appreciated. :slight_smile:
Btw. I already updated the firmware.

Kind regards,
Domi

Hello everyone, if you have any advice I would be glad if you could guide me in a direction. I have a video on google drive, if you want to have a look:
Link to video

Maybe it has something to do with the machine settings? (Trouble with X Axis)

Kind regards,
Dom

Ok problem solved :slight_smile:
The control panel with the move buttons was defect. The motherboard always falsely detected ghost touches, and after unplugging the control panel from the motherboard, the movement stopped. However, I could not use the touch panel and contacted the shop where I bought it and they sent me a new touch panel and motherboard so I am happy now :slight_smile:

1 Like