Level sensor data communication anomaly

Hi
After many happy and successful prints over the last year my cr-10 se came up with the error in the topic heading. A quick search on line suggests the problem is with the wiring to the print bed heating but I would be thankful if anyone out there can help me resolve the issue. 70 years old and retired and the pension don’t stretch to a new printer, thanks

Last weekend my printer (cr10 se) had the same error. The error in my case was the load cell / strain gauge. Check this post for the solution: What is this part on the CR-10 SE?

In my case the load cell was not broken, but its signal was not detected by the printer. I disabled it in printer.cfg and did manual z offset correction.