@Devinhamby
I had the same error on mine this morning, the newest firmware, too.
This happened to me, during a 15-hour print, halfway through the night, something crashed in the firmware, the camera died, the time-lapse died too, but not just visually, it stopped recording at the time of the failure.
I can see the failure in the print too, whatever happened, halfway through the print there is a huge shift in the layers to one side, which caused a mess inside my printer and the upper layers that adhered to what they could. (see pics).
The only thing I did to clear this error was to turn the unit off for a couple of minutes, rebooted it and did a full self check. I am now running the same print for the next 14 hours and hope this does not happen again, if it does, I am rolling back my firmware and will report this issue.
One other thing, I have printed about 7 others of these pre-firmware update without issues.