Nozzle keeps picking filament off the bed and drags it around, ruining print

Whenever I go to print anything big on my printer, the nozzle will drag filament around because one section of the print is not adhered to the bed, and it is only this one spot. I have glue on the bed, but It does not seem to help. Can someone help me with this?

It sounds like your nozzle is too high and needs adjusting down with z-offset.

What printer do you have? The V3 shouldn’t need glue.

If i were printing TPU I would use gluestick as a release agent layer, TPU sticks a little too well to PEI sheets so the glue is a great help.

It’s a v3 se, and I just realized this, but the software highlighted the bottom layer and said it could not process it right and that might be why because I reset the configuration and re leveled it. Thank you for the help!