Rough first layer of print PLA

I’m sure this topics been posted 100 times so sorry!
I’m new to 3D printing. I have a ender 3 v2 neo. And on my first layer I’m getting good bed adhesion but a rough print! Would love some advice!

Hi @Sgerber and welcome to the forums!

Usually when you see ridges in your print surface it is as a result of the nozzle being slightly too close to the bed, try running the print again but baby-step your z offset up slightly until you notice a nice even lay. If you notice gaps between the lines then the nozzle is too high.

Hope that helps.