So, Runout Sensor + Octoprint on Ender3V3SE: Did I just spend "Money For Nothing"? (Cue 'Dire Straits')

[Mikey_Mike_Mik]

Just an FYI: We are coming close to a solution here:

Ender-3 V3 SE: config settings to roll our own firmware please

This is good! My Octoprint doesn’t look like this! Can I ask what plugins you have running? Try adding these scripts to Octoprint Settings->Printer->GCODE After print job is paused: {% if pause_position.x is not none %} ; relative XYZE G91 M83 ; retract filament, move Z slightly upwards G1 Z+5 E-5 F4500 ; absolute XYZE M82 G90 ; move to a safe rest position, adjust as necessary G1 X0 Y0 ; relative XYZE here so that you can adjust your filament via octoprint while paused G91 M83 {% endif %}…

Come join in the fun!

Mike