So, I’ve had my v3 se for about 8 months. Never had a single issue with stringing. Suddenly, I have a terrible issue with stringing. Two things have changed. One, I used up my Creality nozzles and bought a 20 pack of nozzles on Amazon. The other is I started printing with a PLA+ that is crazy tough and sticky. Like, if it cools in the nozzle, the nozzle is trashed. This pic is with a brand new nozzle, and with a filament I’ve had no issue with in the past. All of my filament is put in the drier before I print with it. Creality Print software with no overrides. Yesterday I had retraction all the way up to 4 and distance up to 5, and while there was some improvment, there was still an unacceptable amount of stringing. Is it possible some of that PLA+ is jammed up in the hot end somewhere and is preventing adequate retraction? I’m pretty stumped and could use some veteran advice. Thank you in advance everyone!
