Adhesion problem to the plate

[Nikoli]

Possible cross-post…

I'm looking for the best settings for Orca Slicer and Ender 3 V3 SE (0.4mm and 0.2mm)

Hello everyone I recently purchased an Ender 3 v3 SE and have tried different slicers. I initially installed Prusa with presets downloaded from github, but a lot of filaments were generated during printing. subsequently I managed to find a compromise with the presets of the new version of orca, modifying the organic supports so that they detached easily from my 25mm pla miniatures. wanting to try to improve the quality of my small prints, I had also tried cura maker, but inexplicably with the s…