Ender-3 V3 SE: config settings to roll our own firmware please

Ender Series Creality Ender-3 V3 KE/SE
200

Hi, nope this firmware that I’m working with was edited with the goal of showing:

  • Time of the print. Calculated by Octoprint, or Print Time Genius or from M73 command. :white_check_mark:

  • Print Time left. Same as above. :white_check_mark:

  • Layer progress. :white_check_mark:

  • Percentage of progress. Based on Time elapsed, or Layer or M73 command.

  • The thumbnail of the GCODE. Since no documentation found I’m trying to brute force the access to the memory of LCD so for now we just see the Standard Creality superMan :x:

  • Fully integrated with Octoprint rather than standalone. This because I use heavily Octoprint. I would say the integration is working fine with the help of the plugin. Without the Octoprint plugin installed you will not see the updates in the LCD.

So the disposition of the LCD GUI went a little bit different but trying to keep the same layout and look and feel. The LCD is super tiny so can’t add much on it.