I want Help Dialing In My Ender-3 V3 KE – Layer Shifting Issues?

Ender Series Creality Ender-3 V3 KE/SE
1

Hey everyone,

I got my Ender-3 V3 KE set up last week & I am still kinda new to this whole 3D printing thing . Everything went pretty smoothly during setup but I have run into a weird issue with layer shifting on taller prints. The first few layers look solid but then around the 30-40mm mark, the layers start shifting slightly & it throws off the whole print.

Also I have double-checked the bed leveling & belts — they seem fine but maybe I am missing something? Could it be something with the slicer settings? I am using Cura with the default Creality profile. Also want to know if it might be related to speed or acceleration settings?

I see this post New Ender 3 V3 KE Self-check issue blue-prism-certi I appreciate any advice from folks who have been using the V3 KE longer — what should I check or tweak first?

Thank you…:slight_smile:

2

Hello Sofiaya,

would you be able to give a bit more information, such as, the type of filament and what you are setting the temperature at ?

Cheers.